United States Stove DR6 Owner's Manual download pdf (Page 4)



AS A LOCATION IS SELECTED, KEEP THE FOLLOWING MIND:

1. The chimney connection should be as airtight

as possible. The heater must have its own

chimney ue. Do not connect this unit to a

chimney ue serving another appliance. If

there is no chimney near where you wish to

place the heater, you can use a UL 103HT

Residential Type and Building Heating Ap-

pliance Chimney.

2. Place the heater on solid masonry or solid

concrete. When the heater is used on a

combustible oor, use a non-combustible

oor protector of one layer of 3/8" millboard

having a thermal conductivity of K=0.84 BTU

in./ft. 2 hr. Deg. F with 28-gauge sheet metal

or a UL Listed oor protector. Have the oor

protector extend 16" beyond the door side

of the heater and under the connector pipe

in the back.

3. Check Figures 2, 3, and 4. Be sure you have

the clearances shown from the heater and

the connector pipe to combustible surfaces.

If you have a solid brick or stone wall behind

your heater, you can place the heater as

close as you wish to the wall. If the wall is

only faced with brick or stone, treat it as a

combustible wall.

4 3/4

(121mm)

54

(1.37M)

*16

(406mm)

25

(635mm)

35

(989mm)

12

(305mm)

25

(635mm)

*17

(432mm)

12

(305mm)

36

(914mm)

INCHES (METRIC)

NOTE: DASHED LINES SHOW

STRAIGHTUP AND DOWN THROUGH

THE WALL INSTALLATION.

*CANADIAN INSTALLATIONS REQUIRE

A MINIMUM OF 18” (450mm) ON THE

FUEL LOADING SIDE AND 8”(203mm)

ON ALL OTHER SIDES.

NON-COMBUSTIBLE CONSTRUCTION

IN ACCORDANCE WITH NFPA 211

AND CAN/CSA-B365-M91



Slide rebricks toward the rear so no

gaps remain between them.



Keep furnishings and other combus-

tible materials away from the heater.



4 21



Clearances stated above may ONLY be reduced

by means approved by the regulatory authority.

DO NOT CONNECT TO OR USE IN CONjUNCTION WITH

ANY AIR DISTRIBUTION DUCT OR SYSTEM.

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments