United States Stove DR6 Owner's Manual download pdf (Page 12)

MACHINE SCREW

CABINET DOOR KNOB



The cabinet door knob is mounted on the

inside of the cabinet door to facilitate

shipping and must be removed and re-

installed for proper usage.

To get the cabinet door open, place

your hand under the cabinet frame (right

hand side of the cabinet door) and push

door out.

FOLLOW THESE INSTRUCTIONS FOR DOOR

KNOB ASSEMBLY:

1. Remove the machine screw and the

door knob.

2. Place the knob on the outside of the

cabinet door, re-install the machine

screw and tighten being careful not to

strip out the threads in the plastic handle.



NOTICE: The CB36 is standard equipment on the

model B2350B. If you wish to purchase an as-

sembly, you can contact your dealer for details

or get it directly from the U.S. Stove Company.

INSTALLATION

1. Remove the Panel (A) using tin snips or

knock out using a hammer and chisel care-

ful not to distort the mounting surface.

2. Attach the Blower Mounting Box (B) to the

rear of the unit using four(4) of the supplied

#10 screws.

3. Then mount the Blower Assembly with the

four(4) remaining screws.

OPERATION

1. Rotating the rheostat control

knob clockwise will turn ON the

blower.

2. When turned on, the blower

comes on HIGH, then as the

knob is rotated clockwise, the

blower speed reduces.

3. Rotate the knob counter-clock-

wise to turn OFF.

Follow these instructions to operate you unit safely when operating the feed door.

NOTE:

DURING OPENING AND CLOSING OF THE FEED AND ASH DOORS OF THIS HEATER, IT MAY

SEEM THAT THE FIT OF THE DOOR IS "TOO TIGHT". AS THE HEATER IS FIRED, THE GASKETING

"SETTLES" OR "SEATS" ITSELF IN THE DOOR. THE TIGHT FIT AT THE FACTORY AND BEFORE

THE HEATER'S INITIAL FIRING IS TO INSURE A GOOD SEAL AFTER THE GASKETING "SETTLES".



NOTE:

THIS NEW LATCHING MECHANISM MEETS CODES AND PROVIDES MORE

SAFETY FOR THE USER OF THIS STOVE.

1. Turn handle clockwise to the 12 o'clock

position (A), pull the door open until you

engage the second step (B).

2. Hold the door in that position for ap-

proximately 10 seconds.

3. Then to open door, turn the handle

counter clockwise to the 9 o'clock

position (C) and then continue to pull

the door open. (D)

4. To close and latch the door, reverse

steps 1 thru 4.



CAUTION! DO NOT OPEN OR CLOSE THE TOP WHEN THE HEATER IS HOT!

To open, grasp the top at the front or on each

corner and lift all the way up until the support

rod stops the motion. Then gently lower the top

allowing the support rod to settles in the cup,

holding the top open.

To Close, lift the top until the support rod is out

of the cup. Pull the rod forward and lower the

lid closed.

12 13

Caution! Route the Power Supply Cord

away from the heat source and out of high

trafc areas.

1 2 ... 7 8 9 10 11 12

Comments to this Manuals

No comments

United States Stove DR6 Owner's Manual Page 12

Comments to this Manuals