United States Stove 2500 Owner's Manual download pdf (Page 3)

USSC 3

ASSEMBLY

Assembly

1. Unpack unit and make sure all components are included; (4) Legs,

and all hardware for installation.

2. Fold the corner padding from the carton and lay it on the floor behind

the unit. This is used to hold the heater up off the floor to install the legs.

Gently tilt the heater on its back, door opening up.

3. Assemble the legs as shown using the eight(8) bolts supplied.

4. After all bolts and screws have been tightened properly, carefully set

the heater back up on the legs.

1. The Auger is packed in the hopper or ash

pan and must be installed properly as illustrated

below.

2. Insert the Auger into the auger tube. Rotate

the auger until it fits into the coupling that is

already installed on the auger motor drive. Seat

the auger firmly. The Auger cannot be turned

by hand once installed properly.

6039T ASSEMBLY

6039 PEDESTAL TRIM ASSEMBLY

Assemble trim pieces as shown with the screws

provided in the parts bag.

After trim assembly, attach to the pedestal base at the

location shown using the screws provided.

1 2 3 4 5 6 7 8 ... 31 32

No comments

United States Stove 2500 Owner's Manual Page 3